Server

The server command is used when the node operates in client mode with the NTP server specified in the address field. Use the no form of this command to remove the server with the specified address from the configuration. Up to five NTP servers can be configured.

Use the following CLI syntax to configure the node to operate in client mode.

config>system>time>ntp
        server {ip-address |ptp} [key-id key-id] [version version] [prefer]

Example: Command usage to configure the node to operate in client mode

config>system>time>ntp# 
    config>system>time>ntp# server 192.168.1.1 key-id 1
    config>system>time>ntp# no shutdown
Example

The following is a sample configuration output of NTP enabled with the server command configured.

A:7210SAS>config>system>time>ntp# info 
----------------------------------------------
                ntp-server
                server ptp prefer
                broadcast interface "a1"
                no shutdown
----------------------------------------------
A:7210SAS>config>system>time>ntp#