card slot-number
config
Supported on all 7210 SAS platforms as described in this document
This mandatory command enables the context to access the chassis card Input/Output Module (IOM), slot, and MDA CLI context.
The no form of this command cannot be used on fixed IOM and MDA cards that are auto equipped and auto provisioned. The IOM card is equipped and provisioned for slot 1.
Specifies the slot number of the card in the chassis.
card-type card-type
config>card
Supported on all 7210 SAS platforms as described in this document
This mandatory command adds a card type to the device configuration for the slot. The card type can be preprovisioned, meaning that the card does not need to be installed in the chassis.
A card must be provisioned before an MDA or port can be configured.
A card can only be provisioned in a slot that is vacant, meaning no other card can be provisioned (configured) for that particular slot.
A card can only be provisioned in a slot if the card type is allowed in the slot. An error message is generated if an attempt is made to provision a card type that is not allowed.
A high severity alarm is raised if an administratively enabled card is removed from the chassis. The alarm is cleared when the correct card type is installed or the configuration is modified. A low severity trap is issued when a card is removed that is administratively disabled.
An appropriate alarm is raised if a partial or complete card failure is detected. The alarm is cleared when the error condition ceases.
The no form of this command cannot be used as the card is fixed.
the card is equipped and preprovisioned for slot 1
Specifies the type of card to be configured and installed in that slot.