access
config>port
Supported on all 7210 SAS platforms as described in this document
Commands in this context configure QoS policy parameters on an access port.
uplink
config>port>access
Supported on all 7210 SAS platforms as described in this document
Commands in this context configure QoS policy parameters on an access-uplink port.
egress
config>port>access
config>port>access>uplink
Supported on all 7210 SAS platforms as described in this document
Commands in this context configure QoS egress policy parameters for the access port on 7210 SAS-D and 7210 SAS-Dxp, and for the access-uplink port on 7210 SAS-D, 7210 SAS-Dxp, 7210 SAS-K 2F1C2T, 7210 SAS-K 2F6C4T, and 7210 SAS-K 3SFP+ 8C respectively.
[no] pool [name]
config>port>access>egress
config>port>access>uplink>egress
7210 SAS-D, 7210 SAS-Dxp
This command configures pool policies.
The default pool cannot be modified, deleted or created.
default
Specifies the pool name, a string up to 32 characters composed of printable, 7-bit ASCII characters. If the string contains special characters (#, $, spaces, and so on), the entire string must be enclosed within double quotes.
slope-policy name
no slope-policy
config>port>access>egress>pool
config>port>access>uplink>egress>pool
7210 SAS-D, 7210 SAS-Dxp
This command specifies an existing slope policy which defines high and low priority RED slope parameters. The policy is defined in the config>qos>slope-policy context.
Specifies the policy name, a string up to 32 characters.
qos policy-id
no qos
config>port>ethernet>access>egress
7210 SAS-D, 7210 SAS-Dxp
This command associates a access-egress QoS policy to the access port.
The no form of this policy removes the explicit association of a user configured QoS policy and associates a default QoS policy with the port.
Specifies an existing QoS policy to be assigned to the port.
qos policy-id
no qos
config>port>ethernet>access>uplink
Supported on all 7210 SAS platforms as described in this document
This command associates a network QoS policy with the access-uplink port.
Specifies an existing QoS policy to be assigned to the port.
nw-egr-agg-shaper-rate rate
no nw-egr-agg-shaper-rate
config>port>ethernet>network
7210 SAS-K 2F6C4T and 7210 SAS-K 3SFP+ 8C
This command specifies the network egress aggregate shaper rate for port queues. The shaper value limits the maximum bandwidth that port queues can receive from the total port bandwidth, with remaining port bandwidth shared by SAPs on the port. This command is only supported on hybrid ports.
The no form of this command removes the configured egress aggregate shaper rate.
no nw-egr-agg-shaper-rate
Specifies the egress aggregate shaper rate in kb/s.
qos policy-id
no qos
config>port>ethernet>network
7210 SAS-K 2F6C4T and 7210 SAS-K 3SFP+ 8C
This command associates a network QoS policy to a network port.
Specifies an existing QoS policy to be assigned to the port.