MDA commands

Context

config>card

Platforms

Supported on all 7210 SAS platforms as described in this document

Description

This mandatory command enables the MDA CLI context to configure MDAs.

Default

1

Parameters

mda-slot

Specifies the MDA slot number to be configured. Fixed ports on the panel of the chassis belong to MDA 1.

Context

config>card>mda

Platforms

Supported on all 7210 SAS platforms as described in this document

Description

This mandatory command provisions a specific MDA type to the device configuration for the slot. The MDA can be preprovisioned but an MDA must be provisioned before ports can be configured. Ports can be configured when the MDA is properly provisioned.

7210 SAS-D and 7210 SAS-Dxp (all platform variants) support only a fixed MDA. These platforms do not support an expansion slot. The fixed MDA (addressed as mda 1) is auto-equipped and auto-provisioned on bootup. It cannot be deleted.

The no form of this command displays an error message if performed on fixed MDAs.

Default

MDA 1 is auto-equipped and auto-provisioned by default during bootup.

Parameters

mda-type

Specifies the type of MDA selected for the slot position.

Values

m4-tx+6-sfp (7210 SAS-D)

m6-tx+4-sfp+2-sfpp (7210 SAS-Dxp)

m2-tx+2-sfp+1-combo (7210 SAS-K 2F1C2T)

m4-tx+2-sfp+6-combo (7210 SAS-K 2F6C4T)

m3-10gb-sfp+8-combo (7210 SAS-K 3SFP+ 8C)

Context

config>card>mda

Platforms

Supported on all 7210 SAS platforms as described in this document

Description

This command enables Synchronous Ethernet on the Ethernet ports that support Synchronous Ethernet. When Synchronous Ethernet is enabled, the timing information is derived from the Ethernet ports.

Synchronous Ethernet is supported for both Ethernet SFP ports and fixed copper ports.

See the 7210 SAS-D, Dxp, K 2F1C2T, K 2F6C4T, K 3SFP+ 8C Basic System Configuration Guide for more information about Synchronous Ethernet.

The no form of this command disables Synchronous Ethernet on the MDA.

Default

no sync-e