egress
config>router>interface
7210 SAS-K 2F6C4T and 7210 SAS-K 3SFP+ 8C
Commands in this context configure egress network filter policies for the IP interface. If an egress filter is not defined, no filtering is performed.
ingress
config>router>interface
7210 SAS-K 2F6C4T and 7210 SAS-K 3SFP+ 8C
Commands in this context configure ingress network filter policies for the IP interface. If an ingress filter is not defined, no filtering is performed.
filter ip ip-filter-id
no filter
config>router>if>ingress
config>router>if>egress
7210 SAS-K 2F6C4T and 7210 SAS-K 3SFP+ 8C
This command associates an IP filter policy with an IP interface.
Filter policies control packet forwarding and dropping based on IP match criteria.
The ip-filter-id must have been preconfigured before this filter command is executed. If the filter ID does not exist, an error occurs.
Only one filter ID can be specified.
For more information about service and IP interface support for different ACL match criteria for each platform, see Filter policy entities.
The no form of this command removes the filter policy association with the IP interface.
Specifies the ID for the IP filter policy, expressed as a decimal integer. The filter policy must already exist within the config>filter>ip context.