statistics
config>service>>ies>interface>sap
7210 SAS-D
Commands in this context configure the counters associated with SAP ingress and egress.
egress
config>service>>ies>interface>sap>statistics
7210 SAS-D
Commands in this context configure the egress SAP statistics counter and set the mode of the counter.
This counter counts the number of packets forwarded through the SAP.
ingress
config>service>>ies>interface>sap>statistics
7210 SAS-D
Commands in this context configure the ingress SAP statistics counter.
By default, SAP ingress counters are associated with a SAP and cannot be disabled.
The IES service supports a counter that counts the total packets or octets received on the SAP.
[no] forwarded-count
config>service>ies>if>sap>statistics>egress
7210 SAS-D
This command associates a counter with the SAP. The counter counts the number of packets forwarded through the SAP.
A limited number of such counters are available for use with access SAPs and access-uplink SAPs.
Use this command before enabling applicable accounting record collection on the SAP to associate a counter with the SAP.
The no form of this command disables the packet count.
counter-mode {in-out-profile-count | forward-drop-count}
config>service>ies>interface>sap>statistics>ingress
7210 SAS-D
This command sets the mode of ingress counters associated with the SAP to either octets or packets. On IES SAPs, collect stats cannot be enabled so the mode of the counter can be changed without any reference. Changing the mode of the counter results in loss of previously collected counts and resets the counter.
The no form of this command is not supported.
in-out-profile-count
Keyword to specify that one counter counts the total in-profile packets and octets received on ingress of a SAP and another counts the total out-of-profile packets and octets received on ingress of a SAP. A packet is determined to be in-profile or out-of-profile based on the meter rate parameters configured. A packet is dropped by the policer if it exceeds the configured PIR rate. Dropped counts are not maintained in hardware when this mode is used. It is obtained by subtracting the sum of in-profile count and out-of-profile count from the total SAP ingress received count and displayed.
Keyword to specify that one counter counts the forwarded packets and octets received on ingress of a SAP and another counts the dropped packets. The forwarded count is the sum of in-profile and out-of-profile packets/octets received on SAP ingress. The dropped count is count of packets/octets dropped by the policer. A packet is determined to be in-profile or out-of-profile based on the meter rate parameters configured. A packet is dropped by the policer if it exceeds the configured PIR rate. The in-profile count and out-of-profile count is not individually available when operating in this mode.
[no] received-count
config>service>ies>if>sap>statistics>ingress
7210 SAS-D
This command associates a counter with a SAP. It counts the number of packets and octets received on the SAP (ingress).
A limited number of such counters are available for use with access-uplink SAPs.
Use this command before enabling applicable accounting record collection on the SAP.
The no form of this command disables the counter.