[no] spoke-sdp sdp-id
config>service>vprn
7210 SAS-K 2F6C4T and 7210 SAS-K 3SFP+ 8C
This command binds a service to an existing Service Distribution Point (SDP). The SDP defines the transport tunnel to which this VPRN service is bound.
The SDP has an operational state that determines the operational state of the SDP within the service; for example, if the SDP is administratively or operationally down, the SDP for the service is down.
The SDP must exist in the config>service>sdp context before it can be associated with a VPRN service. If the sdp sdp-id is not already configured, an error message is generated. If the sdp-id exists, a binding between the specific sdp-id and service is created.
SDPs must be explicitly associated and bound to a service to allow far-end routers to participate in the service. Alternatively, auto-bind can be used. With auto-bind, no VPRN spoke-SDP configuration is required. When both auto-bind and spoke-sdp are configured, spoke-sdp takes precedence. The spoke-sdp configuration must be undone for auto-bind to take effect.
The no form of this command removes the SDP binding from the service; the SDP configuration is not affected. When the SDP binding is removed, no packets are forwarded to the far-end router.
Several SDPs can be bound to a VPRN service. Each SDP must be destined to a different 7210 SAS router. If two sdp-id bindings terminate on the same 72107210 SAS, an error occurs and the second SDP binding is rejected.
Specifies the SDP identifier. Allowed values are integers for existing SDPs.
Specifies the virtual circuit identifier.