sap sap-id [create]
no sap sap-id
config>service>ies>if
Supported on all 7210 SAS platforms as described in this document, including those operating in access-uplink mode
This command creates a Service Access Point (SAP) within a service. A SAP is a combination of port and encapsulation parameters which identifies the service access point on the interface and within the router. Each SAP must be unique.
All SAPs must be explicitly created. If no SAPs are created within a service or on an IP interface, a SAP does not exist on that object.
Enter an existing SAP without the create keyword to edit SAP parameters. The SAP is owned by the service in which it was created.
A SAP can only be associated with a single service. A SAP can only be defined on a port that has been configured as an access uplink port using the configure port port number ethernet mode access uplink command.
If a port is shutdown, all SAPs on that port become operationally down. When a service is shutdown, SAPs for the service are not displayed as operationally down although all traffic traversing the service is discarded. The operational state of a SAP is relative to the operational state of the port on which the SAP is defined.
The no form of this command deletes the SAP with the specified port. When a SAP is deleted, all configuration parameters for the SAP is also deleted.
No SAPs are defined.
A SAP is defined within the context of an IP routed interface. Each IP interface is limited to a single SAP definition. Attempts to create a second SAP on an IP interface fail and generate an error; the original SAP is not affected.
Specifies the physical port identifier portion of the SAP definition. See Common CLI command descriptions for command syntax.
Specifies the physical port ID in the slot/mda/port format.
If the card in the slot has Media Dependent Adapters (MDAs) installed, the port-id must be in the slot_number/MDA_number/port_number format. For example 1/1/1 specifies port 1 on MDA 1 in slot 1.
The port-id must reference a valid port type. The port must be configured as an uplink access port.
Keyword used to create a SAP instance. The create keyword requirement can be enabled/disabled in the environment>create context.