Interface VRRP commands support IPv6 addresses on 7210 SAS-Mxp only.
Interface VRRP commands are only supported on 7210 SAS platforms operating in network mode.
config
- service
- vprn service-id [customer customer-id]
- no vprn service-id
- interface ip-int-name
- ipv6
- vrrp virtual-router-id [owner]
- no vrrp virtual-router-id
- [no] backup ip-address
- init-delay seconds
- no init-delay
- [no] master-int-inherit
- message-interval {[seconds] [milliseconds milliseconds]}
- no message-interval
- [no] ping-reply
- policy vrrp-policy-id
- no policy
- [no] preempt
- priority priority
- no priority
- [no] shutdown
- [no] standby-forwarding
- [no] telnet-reply
- [no] traceroute-reply
- vrrp virtual-router-id [owner]
- no vrrp virtual-router-id
- authentication-key {authentication-key | hash-key} [hash | hash2]
- no authentication-key
- [no] backup ip-address
- [no] bfd-enable [service-id] interface interface-name dst-ip ip-address
- init-delay seconds
- no init-delay
- [no] master-int-inherit
- message-interval {[seconds] [milliseconds milliseconds]}
- no message-interval
- [no] ping-reply
- policy vrrp-policy-id
- no policy
- [no] preempt
- priority priority
- no priority
- [no] shutdown
- [no] ssh-reply
- [no] standby-forwarding
- [no] telnet-reply
- [no] traceroute-reply