id service-id
clear>service
clear>service>statistics
7210 SAS-T (network operating mode)
This command clears commands for a specific service.
Specifies the ID that uniquely identifies a service.
statistics
clear>service>stats
7210 SAS-T (network operating mode)
This command clears session statistics for this service.
fdb {all | mac ieee-address | sap sap-id] }
clear>service>id
7210 SAS-T (network operating mode)
This command clears FDB entries for the service.
Clears all FDB entries.
Clears only FDB entries in the FDB table with the specified 48-bit MAC address. The MAC address can be expressed in the form aa:bb:cc:dd:ee:ff or aa-bb-cc-dd-ee-ff where aa, bb, cc, dd, ee and ff are hexadecimal numbers.
Specifies the physical port identifier portion of the SAP definition.
sap service-id
clear>service>statistics
7210 SAS-T (network operating mode)
This command clears statistics for the SAP bound to the service.
See Common CLI command descriptions for the command syntax.
counters
clear>service>statistics>id
7210 SAS-T (network operating mode)
This command clears all traffic queue counters associated with the service ID.
stp
clear>service>statistics>id
7210 SAS-T (network operating mode)
Clears all spanning tree statistics for the service ID.
detected-protocols {all | sap sap-id}
clear>service>id>stp
7210 SAS-T (network operating mode)
RSTP automatically falls back to STP mode when it receives an STP BPDU. This command forces the system to revert to the default RSTP mode on the SAP.
Clears all detected protocol statistics.
Clears the specified lease state SAP information.