[no] spoke-sdp sdp-id
config>service>vprn
Supported on all 7210 SAS platforms as described in this document, except those operating in access-uplink mode
This command binds a service to an existing Service Distribution Point (SDP). The SDP defines the transport tunnel to which this VPRN service is bound.
The SDP has an operational state that determines the operational state of the SDP within the service. For example, if the SDP is administratively or operationally down, the SDP for the service is down.
The SDP must already exist in the config>service>sdp context before it can be associated with a VPRN service. If the sdp sdp-id is not already configured, an error message is generated. If the sdp-id exists, a binding between the specific sdp-id and the service is created.
SDPs must be explicitly associated and bound to a service to allow far-end 7210 SAS devices can participate in the service.
The no form of this command removes the SDP binding from the service; the SDP configuration is not affected. When the SDP binding is removed, no packets are forwarded to the far-end router.
no sdp-id is bound to a service
Several SDPs can be bound to a VPRN service. Each SDP must be destined to a different 7210 SAS router. If two sdp-id bindings terminate on the same 7210 SAS, an error occurs and the second SDP binding is rejected.
Specifies the SDP identifier.
Specifies the virtual circuit identifier.