lldp
config>port>ethernet
Supported on all 7210 SAS platforms as described in this document, including platforms configured in the access-uplink operating mode
Commands in this context configure Link Layer Discovery Protocol (LLDP) parameters on the specified port.
dest-mac {bridge-mac}
config>port>ethernet>lldp
Supported on all 7210 SAS platforms as described in this document, including platforms configured in the access-uplink operating mode
This command configures destination MAC address parameters.
Specifies destination bridge MAC type to use by LLDP.
admin-status {rx | tx | tx-rx | disabled}
config>port>ethernet>lldp>dstmac
Supported on all 7210 SAS platforms as described in this document, including platforms configured in the access-uplink operating mode
This command specifies the administratively desired status of the local LLDP agent.
Specifies that the LLDP agent will receive, but will not transmit LLDP frames on this port.
Specifies that the LLDP agent will transmit LLDP frames on this port and will not store any information about the remote systems connected.
Specifies that the LLDP agent will transmit and receive LLDP frames on this port.
Specifies that the LLDP agent will not transmit or receive LLDP frames on this port. If there is remote systems information which is received on this port and stored in other tables, before the port's admin status becomes disabled, the information will naturally age out.
[no] notification
config>port>ethernet>lldp>dstmac
Supported on all 7210 SAS platforms as described in this document, including platforms configured in the access-uplink operating mode
This command enables LLDP notifications.
The no form of this command disables LLDP notifications.
tx-mgmt-address [system]
no tx-mgmt-address
config>port>ethernet>lldp>dstmac
Supported on all 7210 SAS platforms as described in this document, including platforms configured in the access-uplink operating mode
This command specifies which management address to transmit.
The no form of this command reverts value to the default.
no tx-mgmt-address
Specifies to use the system IP address. If this parameter is specified, the system address will only be transmitted once it has been configured.
tx-tlvs [port-desc] [sys-name] [sys-desc] [sys-cap]
no tx-tlvs
config>port>ethernet>lldp>dstmac
Supported on all 7210 SAS platforms as described in this document, including platforms configured in the access-uplink operating mode
This command specifies which LLDP TLVs to transmit.
The no form of this command reverts to the default.
no tx-tlvs
Specifies that the LLDP agent should transmit port description TLVs.
Specifies that the LLDP agent should transmit system name TLVs.
Specifies that the LLDP agent should transmit system description TLVs.
Specifies that the LLDP agent should transmit system capabilities TLVs.