Sample output: BOF configuration on bootup for 7210 SAS-Sx/S 1/10GE

Example

The following is a sample output of a manually interrupted boot sequence on the 7210 SAS-Sx/S 1/10GE.

primary-image      cf2:both.tim
#eth-mgmt Port Settings:
    eth-mgmt-disabled
#uplinkA Port Settings:
    uplinkA-port       1/1/25
    no  uplinkA-autoneg
    uplinkA-duplex     full
    uplinkA-speed      10000
    uplinkA-address    0 
    uplinkA-vlan       0
#uplinkB Port Settings:
    uplinkB-port       1/1/26
    no  uplinkB-autoneg
    uplinkB-duplex     full
    uplinkB-speed      10000
    uplinkB-address    0 
    uplinkB-vlan       0
#System Settings:
    wait               3
    persist            off
    console-speed      115200
    no  console-disabled
    primary-image      ftp://*:*@xxx.xxx.xx.x/./images/SASS-hops-both.tim
#eth-mgmt Port Settings:
    eth-mgmt-disabled
#uplinkA Port Settings:
    uplinkA-port       1/1/1
    uplinkA-autoneg
    uplinkA-duplex     full
    uplinkA-speed      1000
    uplinkA-address    xxx.xxx.xx.xxx/24 
    uplinkA-vlan       0
    uplinkA-route      xxx.xxx.x.x/16 next-hop xxx.xxx.xx.x
#System Settings:
    wait               3
    persist            off
    console-speed      115200
    no  console-disabled
   primary-image      ftp://*:*@xx.xxx.xx.xxx/./images/SASS-hops-both.tim
#eth-mgmt Port Settings:
    no  eth-mgmt-disabled
    eth-mgmt-address   xx.xxx.xx.xxx/24 active
    eth-mgmt-route     xx.xxx.x.x/16 next-hop xx.xxx.xx.xxx
    eth-mgmt-autoneg
    eth-mgmt-duplex    full
    eth-mgmt-speed     100
#System Settings:
    wait               3
    persist            off
    console-speed      115200
    no  console-disabled
  primary-image      uf1:both.tim
#eth-mgmt Port Settings:
    eth-mgmt-disabled
#uplinkA Port Settings:
    uplinkA-port       1/1/25
    no  uplinkA-autoneg
    uplinkA-duplex     full
    uplinkA-speed      10000
    uplinkA-address    0 
    uplinkA-vlan       0
#uplinkB Port Settings:
    uplinkB-port       1/1/26
    no  uplinkB-autoneg
    uplinkB-duplex     full
    uplinkB-speed      10000
    uplinkB-address    0 
    uplinkB-vlan       0
#System Settings:
    wait               3
    persist            off
    console-speed      115200
    no  console-disabled