card slot-number
config
Supported on all 7210 SAS platforms as described in this document.
This mandatory command enables the chassis card Input/Output Module (IOM), slot, and MDA CLI context.
The no form of this command cannot be used on fixed IOM and MDA cards that are auto equipped and auto provisioned.
the IOM card is equipped and provisioned for slot 1
Specifies the slot number of the card in the chassis.
card-type card-type
config>card
Supported on all 7210 SAS platforms as described in this document.
This command configures the card slot. The card type can be preprovisioned, meaning that the card does not need to be installed in the chassis.
A card must be provisioned before an MDA or port can be configured.
A card can only be provisioned in a slot that is vacant, meaning no other card can be provisioned (configured) for that particular slot.
A card can only be provisioned in a slot if the card type is allowed in the slot. An error message is generated if an attempt is made to provision a card type that is not allowed.
A high severity alarm is raised if an administratively enabled card is removed from the chassis. The alarm is cleared when the correct card type is installed or the configuration is modified. A low severity trap is issued when a card is removed that is administratively disabled.
An appropriate alarm is raised if a partial or complete card failure is detected. The alarm is cleared when the error condition ceases.
This command is not required for 7210 SAS-T, 7210 SAS-Sx/S 1/10GE (standalone), 7210 SAS-Sx 10/100GE, and 7210 SAS-Mxp devices as the cards are preprovisioned.
In a virtual chassis (VC), when the TiMOS image boots up on the CPM-IMM and the IMM-only cards/nodes, users must provision the card type on each member node so that the software knows which hardware platforms are members of the VC. The software can then determine the logical IMM types that are part of the VC. Provisioning the card type is a mandatory step in the bring up of virtual chassis system in order for all the member nodes to be fully functional.
The no form of this command cannot be used as the IOM card is fixed.
the IOM card is equipped and preprovisioned for slot 1
Specifies the type of card to be configured and installed in that slot.
[no] sys-res-profile policy-id
config>card
7210 SAS-R6, 7210 SAS-12, and 7210 SAS-Sx/S 1/10GE (standalone-VC)
This command attaches the system resource-profile policy. The system resource profile parameters are defined as a policy. The user must configure the system resource profile policy and associate it with the IMM card. The software reads the configured policy and allocates resources appropriately per IMM card. It allows users to allocate resources to different features per IMM card.
On 7210 SAS-R6 and 7210 SAS-R12, some of the system resource profile parameters are applicable to the entire node and not per IMM card.
For more information about the CLI descriptions for System Resource Profile parameters, see the 7210 SAS-Mxp, R6, R12, S, Sx, T Basic System Configuration Guide.
system attaches the default system resource-profile to each IMM when it is booted up
Specifies the system resource profile policy to use for this card.