saa test-name [owner test-owner] {start | stop} [no-accounting]
oam
Supported on all 7210 SAS platforms as described in this document, including platforms configured in the access-uplink operating mode
This command starts or stops an SAA test.
Specifies the name of the SAA test. The test name must already be configured in the config>saa>test context.
Specifies the owner of an SAA operation up to 32 characters.
Starts the test. A test cannot be started if the same test is still running.
A test cannot be started if it is in a shut-down state. An error message and log event are generated to indicate a failed attempt to start an SAA test run. A test cannot be started if it is in a continuous state.
Stops a test in progress. A test cannot be stopped if it is not in progress. A log message is generated to indicate that an SAA test run has been aborted. A test cannot be stopped if it is in a continuous state.
Disables the recording results in the accounting policy. If no-accounting is specified, the MIB record produced at the end of the test is not added to the accounting file. It does however use up one of the three MIB rows available for the accounting module to be collected.