Configuring IPv6 parameters

Example

The following is a sample interface configuration output showing the IPv6 default configuration when IPv6 is enabled on the interface.

*A:dut-d>config>router>if>ipv6# info detail 
----------------------------------------------
                icmp6
                    packet-too-big 100 10
                    param-problem 100 10
                    redirects 100 10
                    time-exceeded 100 10
                    unreachables 100 10
                exit
                address 2001:db8::1/64 
                no dad-disable
                no reachable-time
                no neighbor-limit
                no qos-route-lookup
                no local-proxy-nd
                no tcp-mss
---------------------------------------------- 

Use the following syntax to configure IPv6 parameters on a router interface.

config>router# interface interface-name
    port port-name
    ipv6
        address {ipv6-address/prefix-length} [eui-64]
        icmp6
            packet-too-big [number seconds]
            param-problem [number seconds]
            redirects [number seconds]
            time-exceeded [number seconds]
            unreachables [number seconds]
            neighbor ipv6-address mac-address
Example

The following is a sample configuration output showing interface information.

A:ALA-49>config>router>if# info
----------------------------------------------
     address 10.11.10.1/64
     port 1/1/10
     ipv6
          address 2001:db8::1/64
     exit
----------------------------------------------
A:ALA-49>config>router>if#