alarms
config>system
Supported on all 7210 SAS platforms as described in this document, including those configured in the access-uplink operating mode.
Commands in this context configure facility alarm parameters.
max-cleared maximum
config>system>alarms
Supported on all 7210 SAS platforms as described in this document, including those configured in the access-uplink operating mode
This command configures the maximum number of cleared alarms that the system will store and display.
500
Specifies the maximum number of cleared alarms.
[no] shutdown
config>system>alarms
Supported on all 7210 SAS platforms as described in this document, including those configured in the access-uplink operating mode
This command enables or disables the facility alarm functionality. When enabled, the facility alarm sub-system tracks active and cleared facility alarms and controls the alarm LEDs on the CPMs and CFMs. When facility alarm functionality is enabled, the alarms are viewed using the show system alarms commands.
Shutting down the system alarms clears all existing alarms (raised and cleared). Performing no shutdown will not bring back the earlier raised alarm.
no shutdown