ingress
config>service>ies>if>vpls
Supported on all 7210 SAS platforms as described in this document
Commands in this context define the routed ip-filter-id optional filter overrides.
[no] enable-table-classification
config>service>ies>if>vpls>ingress
Supported on all 7210 SAS platforms as described in this document
This command enables and disables the use of IP DSCP table-based classification to assign FC and profile on a per-interface ingress basis.
The match-criteria configured in the service ingress policy, which require CAM resources, are ignored. Only meters from the service ingress policy are used (and the meters still require CAM resources). If an IP DSCP classification policy is configured in the VPLS SAP ingress policy, it is not used to assign FC and profile.
The no form of this command disables table-based classification. When disabled, the IP ingress packets within a VPLS service attached to the IP interface use the SAP ingress QoS policy applied to the virtual port used by the packets, when defined.
no enable-table-classification
routed-override-qos-policy policy-id
no routed-override-qos-policy
config>service>ies>if>vpls>ingress
Supported on all 7210 SAS platforms as described in this document
This command specifies an IP DSCP classification policy that is applied to all ingress packets entering the VPLS service. The DSCP classification policy overrides any existing SAP ingress QoS policy applied to SAPs for packets associated with the routing IP interface. The routed override QoS policy is optional and when it is not defined or it is removed, the IP routed packets use the existing SAP ingress QoS policy configured on the VPLS virtual port.
The no form of this command is used to remove the IP DSCP classification policy from the ingress IP interface. When removed, the IP ingress routed packets within a VPLS service attached to the IP interface use the SAP ingress QoS policy applied to the virtual port used by the packets, when defined.
no routed-override-qos-policy
Specifies the ID for the routed override QoS policy. Allowed values are an integer in the range of 1 and 65535 that corresponds to a previously created IP DSCP classification policy in the configure>qos>dscp-classification context.
v4-routed-override-filter ip-filter-id
no v4-routed-override-filter
config>service>ies>if>vpls>ingress
Supported on all 7210 SAS platforms as described in this document
This command specifies an IP filter ID that is applied to all ingress packets entering the VPLS service. The filter overrides any existing ingress IP filter applied to SAPs or SDP bindings for packets associated with the routing IP interface. The override filter is optional and when it is not defined or it is removed, the IP routed packets uses the any existing ingress IP filter on the VPLS virtual port.
The no form of this command is used to remove the IP routed override filter from the ingress IP interface. When removed, the IP ingress routed packets within a VPLS service attached to the IP interface uses the IP ingress filter applied to the packets virtual port when defined.
Specifies the ID for the IP filter policy. Allowed values are an integer that corresponds to a previously created IP filter policy in the configure>filter>ip-filter context.