Entering Edit Mode

To enter the mode to edit timing references, you must enter the begin keyword at the config>system>sync-if-timing# prompt.

Use the following CLI syntax to enter the edit mode:

CLI Syntax:

config>system>sync-if-timing
    begin

The following error message displays when you try to modify sync-if-timing parameters without entering begin first.

ALU-1>config>system>sync-if-timing>ref1# source-port 1/1/1
MINOR: CLI The sync-if-
timing must be in edit mode by calling begin before any changes can be made.
MINOR: CLI Unable to set source port for ref1 to 1/1/1.
ALU-1>config>system>sync-if-timing>ref1#