Server

The server command is used when the node should operate in client mode with the NTP server specified in the address field. Use the no form of this command to remove the server with the specified address from the configuration.

Up to five NTP servers can be configured.

CLI Syntax:

config>system>time>ntp
    server {ip-address | ipv6-address} [key-id key-id] [version version] [prefer]

Example:

config>system>time>ntp# server 192.168.1.1 key-id 1
config>system>time>ntp# no shutdown

The following example shows NTP enabled with the server command configured.

A:sim1>config>system>time>ntp# info
----------------------------------------------
            no shutdown
            server 192.168.1.1 key 1 
----------------------------------------------
A:sim1>config>system>time>ntp#