1.1 STS1 with channelized DS3 payload

To configure a DS1 on an STS1 with a channelized DS3 payload:

1. Create the STS1 path and set the payload to DS3.

2. Create the TDM DS3 with channelized DS1.

3. Create the TDM DS1.

Use the info command to display configuration information.

         sonet-sdh
             framing sdh
             path sts1-1
                 payload ds3
                 no shutdown
             exit
         exit
         tdm
             ds3 1
                 channelized ds1
                 no shutdown
             exit
             ds1 1.1
                 no shutdown
             exit
         exit
         no shutdown

Notes:

• the CLI identifier for the path command is sts1-stsNum:

  • where stsNum is between 1 and 3

• the CLI identifier for the TDM ds3 command is ds3Num, where:

  • ds3Num is equal to stsNum

  In the example above, DS3 is configured on sts1-1, hence the command ds3 1. If sts1-2 or sts1-3 was configured instead of sts1-1, the corresponding ds3 configuration would be ds3 2 or ds3 3, respectively.

• the CLI identifier for the TDM ds1 command is ds3Num.ds1Num, where:

  • ds1Num is between 1 and 28 because a DS3 can carry 28 T1s