atm
config>port>multilink-bundle>ima
config>port>tdm>ds1>channel-group
config>port>tdm>e1>channel-group
config>port>tdm>ds3
config>port>tdm>e3
config>port>sonet-sdh>path
This command enables the context to configure ATM interface properties.
cell-format cell-format
no cell-format
config>port>multilink-bundle>ima>atm
config>port>tdm>ds1>channel-group>atm
config>port>tdm>e1>channel-group>atm
config>port>tdm>ds3>atm
config>port>tdm>e3>atm
config>port>sonet-sdh>path>atm
This command configures the ATM cell format.
The no form of this command restores the default value.
uni
the ATM cell format, either UNI or NNI (SONET/SDH ports do not support the NNI format)
mapping direct
no mapping
config>port>tdm>ds3>atm
This command specifies the ATM cell mapping to be used on this DS3 ATM interface.
The no form of this command restores the default value.
For an E3 interface, the mapping command does not appear in the CLI; the interface is hard-coded for direct mapping.
direct
specifies direct cell mapping
min-vp-vpi value
no min-vp-vpi
config>port>multilink-bundle>ima>atm
config>port>tdm>ds1>channel-group>atm
config>port>tdm>e1>channel-group>atm
config>port>tdm>ds3>atm
config>port>tdm>e3>atm
config>port>sonet-sdh>path>atm
This command sets the minimum allowable virtual path identifier (VPI) value that can be used on the ATM interface for a virtual path connection (VPC).
The no form of this command restores the default value.
0
the minimum allowable VPI value that can be used on the ATM interface for a VPC