port {port-id | bundle-id}
no port {port-id | bundle-id}
config
This command enables access to the context to configure ports, multilink bundles, and IMA groups. Before a port can be configured, the chassis slot must be provisioned with a valid card type and the adapter card slot must be provisioned with a valid adapter card type. (See the card and mda commands.)
n/a
specifies the physical port ID in the slot/mda/port format, or a virtual port (v-port) on the 2-port 10GigE (Ethernet) Adapter card or 2-port 10GigE (Ethernet) module (where port-id for the virtual port is either ‟v-port” or 3)
specifies the multilink bundle identifier
The command syntax must be configured as follows:
Syntax |
bundle-type-slot/mda.bundle-num |
||||||
bundle[-ppp]-slot/mda.bundle-num (Creates a multilink PPP bundle) |
|||||||
bundle-ima-slot/mda.bundle-num (Creates an IMA group) |
|||||||
bundle: keyword |
|||||||
slot: card/adapter card slot numbers |
|||||||
bundle-num: 1 to 32 For example: router1>config# port bundle-1/1.1 (multilink PPP bundle) router1>config# port bundle-ima-1/1.2 (IMA group bundle) |
|||||||
[no] ddm-events
config>port
This command enables or disables digital diagnostic monitoring (DDM) events for the port. DDM is supported on Ethernet SFP ports, OC3 SONET SFP ports, and v-ports.
no ddm-events
dwdm
config>port
This command configures the Dense Wavelength Division Multiplexing (DWDM) parameters.
channel channel
config>port>dwdm
This command configures the DWDM ITU channel for a tunable adapter card optical interface. The channel is expressed in a form that is derived from the laser's operational frequency. For example, 193.40 THz corresponds to DWDM ITU channel 34 in the 100 GHz grid and 193.45 THz corresponds to DWDM ITU channel 345 in the 50 GHz grid. The provisioned adapter card must support DWDM tunable optics. For a complete list of supported optics and associated adapter cards, contact your Nokia representative.
The DWDM channel must be set to a non-zero value before the port is set to no shutdown.
The port must be shut down before changing the DWDM channel, and the port must be a physical port to set the DWDM channel.
specifies the channel