gnss
config>port
This command enters the context to perform GNSS receiver port configuration.
n/a
antenna-cable-delay 0 .. 32767
no antenna-cable-delay
config>port>gnss
This command configures the expected signal delay resulting from the length of the antenna cable.
The no form of this command returns the value to the default.
0
the signal delay, in nanoseconds
elevation-mask-angle 0 .. 89
no elevation-mask-angle
config>port>gnss
This command configures the elevation mask angle. It provides a method of filtering satellites to be used by the system.
Configuring an elevation mask angle below 10° is not recommended.
The no form of this command returns the value to the default.
10
the elevation mask angle, in degrees.
[no] type [gps] [glonass]
config>port>gnss
This command configures which GNSS system or systems will be used by the GNSS receiver.
The no form of this command removes the specified GNSS system or systems.
By default, gps is configured. Configuring glonass does not remove gps; the GNSS receiver will use both GPS and GLONASS systems.
gps
configures the GNSS receiver to use the American GPS GNSS system
configures the GNSS receiver to use the Russian GLONASS GNSS system