MPLS OAM tools LSP ping and LSP trace can operate with LDP IPv6 and support the following:
use of IPv6 addresses in the echo request and echo reply messages, including in DSMAP TLV, as per RFC 4379
use of LDP IPv6 prefix target FEC stack TLV, as per RFC 4379
use of IPv6 addresses in the DDMAP TLV and FEC stack change sub-TLV, as per RFC 6424
use of 127/8 IPv4 mapped IPv6 address; that is, in the range ::ffff:127/104, as the destination address of the echo request message, as per RFC 4379
use of 127/8 IPv4 mapped IPv6 address; that is, in the range ::ffff:127/104, as the path-destination address when the user wants to exercise a specific LDP ECMP path
The behavior at the sender and receiver nodes supports both LDP IPv4 and IPv6 target FEC stack TLVs. Specifically:
The IP family (IPv4/IPv6) of the UDP/IP echo request message always matches the family of the LDP target FEC stack TLV as entered by the user in the prefix option.
The src-ip-address option is extended to accept IPv6 address of the sender node. If the user did not enter a source IP address, the system IPv6 address is used. If the user entered a source IP address of a different family than the LDP target FEC stack TLV, an error is returned and the command is aborted.
The IP family of the UDP/IP echo reply message must match that of the received echo request message.
For lsp-trace, the downstream information in DSMAP/DDMAP is encoded as the same family as the LDP control plane of the link LDP or targeted LDP session to the downstream peer.
The sender node inserts the experimental value of 65503 in the Router Alert Option in the echo request packet IPv6 header, as per RFC 5350. After a value is allocated by IANA for MPLS OAM as part of draft-ietf-mpls-oam-ipv6-rao, it is updated.
VCCV ping and VCCV trace for a single-hop PW support IPv6 PW FEC 128, as per RFC 6829. In addition, the PW OAM control word is supported with VCCV packets when the control-word option is enabled on the spoke SDP configuration. When the value of the Channel Type field is set to 0x57, it indicates that the Associated Channel carries an IPv6 packet, as per RFC 4385.