atm-ping {port-id|bundle-id[:vpi|vpi/vci]}[end-to-end | segment][dest destination-id][send-count send-count][timeout timeout][interval interval]
oam
This command tests ATM path connectivity on an ATM VCC.
This command is not supported on ATM VCC SAPs that are members of a SAP aggregation group.
specifies the ID of the access port of the target VC. This parameter is required.
specifies whether the ATM OAM loopback cell is destined for the first segment point in the line direction or the PVCC connection endpoint
defines the LLID field in an OAM loopback cell. If set to all 1s, only the connection end (end-to-end ping) or segment end (segment ping) will respond to the ping. If the segment parameter is specified and dest is set to a specific destination, only the destination will respond to the ping.
the number of messages to send, expressed as a decimal integer. The send-count parameter is used to override the default number of message requests sent. Each message request must either time out or receive a reply before the next message request is sent. The message interval value must be expired before the next message request is sent.
specifies the amount of time that the router will wait for a message reply after sending the message request. If the timeout expires, the requesting router assumes that the message response will not be received. Any response received after the request times out will be silently discarded.
This value is used to override the default timeout value.
specifies the minimum amount of time that must expire before the next message request is sent
If the interval is set to 1 s, and the timeout value is set to 10 s, then the maximum time between message requests is 10 s and the minimum is 1 s. This depends upon the receipt of a message reply corresponding to the outstanding message request.
This parameter is used to override the default request message send interval.