Configuring Per-VLAN Network Egress Shapers

Per-VLAN network egress shapers can be configured for network interfaces.

The queue-policy command is used to enable and disable the network egress per-VLAN shapers on a per-interface basis. If the no queue-policy command is used, the VLAN (that is, the interface) defaults to unshaped mode. The agg-rate-limit command cannot be accessed unless a network queue policy is assigned to the interface.

Use the following CLI syntax to configure a per-VLAN network egress shaper on a network interface. Refer to the 7705 SAR Router Configuration Guide for command descriptions.

CLI Syntax:

config>router>interface#
        egress 
            queue-policy name 
            agg-rate-limit agg-rate [cir cir-rate]