Fabric shapers support access ingress traffic being switched from a SAP to another SAP residing on a port that is part of a Link Aggregation Group (LAG). Either the aggregate mode or destination mode can be used for fabric shaping.
When the aggregate mode is used, one aggregate rate sets the rate on all adapter cards. When the destination mode is used, the multipoint shaper is used to set the fabric shaping rate for traffic switched to a LAG SAP.
Even though the multipoint shaper is used to set the fabric shaping rate for traffic switched to a LAG SAP, it is the per-destination unicast counters that are incremented to show the fabric statistics rather than the multipoint counter. Only the fabric statistics of the active port of the LAG are incremented, not the standby port.