[no] slope-policy name [create]
config>qos
This command enables the context to configure a QoS slope policy.
slope-policy ‟default”
the name of the slope policy
keyword used to create a slope policy
[no] high-slope
config>qos>slope-policy
The high-slope context contains the commands and parameters for defining the high-priority Weighted Random Early Detection (WRED) or Random Early Detection (RED) slope graph. Each queue supports a high-priority WRED/RED slope for managing access to the queue for low-priority or out-of-profile packets.
The high-slope parameters can be changed at any time and the affected queue high-priority WRED/RED slopes will be adjusted appropriately.
The no form of this command restores the high slope configuration commands to the default values. If the commands within high-slope are set to the default parameters, the high-slope mode will not appear in save config and show config output unless the detail parameter is present.
[no] low-slope
config>qos>slope-policy
The low-slope context contains the commands and parameters for defining the low-priority or high-priority WRED/RED slope graph. Each queue supports a low-priority WRED/RED slope for managing access to the queue for low-priority or out-of-profile packets.
The low-slope parameters can be changed at any time and the queue low-priority WRED/RED slopes will be adjusted appropriately.
The no form of this command restores the low slope configuration commands to the default values. If the leaf commands within low-slope are set to the default parameters, the low-slope mode will not appear in save config and show config output unless the detail parameter is present.