This chapter provides information about the GNSS receiver. Topics include:
The GNSS receiver is used for streaming location information from the node (for example, for vehicle position information) or for querying GNSS information on the node.
GNSS services are enabled in the CLI under the cellular MDA (mda 1/1). Use the CLI for the following:
GNSS services are enabled using the config>card>mda>gnss no shutdown command. When GNSS services are enabled, the GNSS receiver begins acquiring GPS and/or GLONASS satellite signals and determines the position of the system. The GPS LED on the chassis blinks green during this process. The GPS LED is lit solid green when the GNSS receiver has determined the position of the node. The GPS LED is unlit when the GNSS receiver is disabled.
When NMEA services are also enabled, NMEA sentences are streamed according to the parameters associated with that service. See Configuring NMEA Parameters for information.
GNSS services are disabled using the shutdown command. When GNSS services are disabled, the GNSS receiver is disabled and satellite information is reset. The GPS LED is unlit when the GNSS receiver is disabled.
GNSS services are disabled by default.
The GNSS receiver generates a logging event when it starts to acquire a position fix and when it has acquired a position fix.
The constellation of the GNSS receiver can be set to either GPS (gps) or GPS and GLONASS (gps-glonass). The constellation can be modified only when the GNSS service is shut down. The default constellation setting is gps.
The node can be configured to send position, velocity, and time information at regular intervals to servers that can process the data. When the data is formatted as an ASCII string according to National Marine Electronics Association (NMEA) standards, it is called an NMEA sentence. The node uses an IP transport service to send NMEA sentences to remote hosts. For information about enabling IP transport for NMEA sentences, refer to the 7705 SAR-Hm and SAR-Hmc Main Configuration Guide, “GNSS NMEA Data IP Transport Service”.
NMEA data streaming is enabled on the node when the IP transport ipt-id parameter is configured as gnss and the nmea no shutdown command is issued.
The following NMEA parameters must be configured on the node when streaming is enabled:
The NMEA defines a number of sentence types for streaming. The node supports the following sentence types:
For information about the sentence types, refer to NMEA 0183, Standard For Interfacing Marine Electronic Devices.
The sentence interval specifies the frequency with which NMEA sentences are sent from the GNSS receiver. The interval can be set from 1 s to 3600 s. Different sentence types can be enabled concurrently so that multiple sentences can be streamed per sentence interval.
The following GNSS location information can be displayed on the CLI:
The following satellite information can be displayed on the CLI for up to 30 satellites: