Ethernet commands

The following commands are supported on 7705 SAR-Hm series nodes. See the 7450 ESS, 7750 SR, 7950 XRS, and VSR Classic CLI Command Reference Guide for the command descriptions.

Note:

Not all commands that are visible in the CLI, and described in the 7450 ESS, 7750 SR, 7950 XRS, and VSR Classic CLI Command Reference Guide and the 7450 ESS, 7750 SR, 7950 XRS, and VSR Clear, Monitor, Show, and Tools Command Reference Guide, are supported on 7705 SAR-Hm series nodes. Only the commands that are listed below are supported.

config 
    - [no] port {port-id}
        - ethernet
            - autonegotiate [limited]
            - no autonegotiate
            - dot1q-etype value
            - no dot1q-etype
            - down-on-internal-error [tx-disable]
            - no down-on-internal-error
            - duplex {full | half}
            - egress-scheduler-override [create]
            - no egress-scheduler-override 
                - levelpriority-level rate pir-rate [cir cir-rate]
                - levelpriority-level percent-rate pir-percent [percent-cir cir-percent]
                - no level priority-level
                - max-rate rate
                - max-rate percent percent-rate
                - no max-rate
            - egress-scheduler-policy port-scheduler-policy-name
            - no egress-scheduler-policy
            - encap-type {dot1q | null}
            - no encap-type
            - hold-time {[up hold-time up] [down hold-time down] [seconds | centiseconds]}
            - no hold-time
            - mac ieee-address
            - no mac
            - min-frame-length byte-length
            - mode {access | network | hybrid} 
            - no mode
            - mtu mtu-bytes
            - no mtu
            - speed {10 | 100}