This section provides information to configure advanced QoS policies using the command line interface.
Topics in this section include:
The adv-config-policy contains queue and policer configuration parameters that are not expected to be useful to most users. In Release 10.0, the policy only contains queue and policer child control parameters within a child-control node.
The parameters within the child-control node are intended to allow more precise control of the method that hierarchical virtual scheduling employs to emulate the effect of a scheduling context upon a member child queue or policer.
Once a policy is created, it may be applied to a queue or policer defined within a sap-egress or sap-ingress QoS policy. It may also be applied to a queue or policer defined within an ingress or egress queue-group template. When a policy is currently associated with a QoS policy or template, the policy may be modified but not deleted (even in the event that the QoS policy or template is not in use).
While the system maintains default values for the advanced configuration parameters, no default adv-config-policy exists.
For information about the tasks and commands necessary to access the command line interface and to configure and maintain your router, refer to CLI Usage chapter in the System Basic Configuration Guide.
A advanced QoS policy must conform to the following:
Configuring and applying advanced policies is optional. If no advanced policy is explicitly applied to a SAP or IP interface, then no default advanced policy is applied.
To create a new advanced policy, define the following:
The following displays an example of an advanced policy configuration:
Apply advanced policies to the following entities:
Use the following CLI syntax to apply advanced policies to ingress queue groups.
Use the following CLI syntax to apply advanced policies to egress queue groups.
Use the following CLI syntax to apply advanced policies to an ingress SAP.
Use the following CLI syntax to apply advanced policies to an egress SAP.
The default policies cannot be edited or deleted. Table 47 displays default advanced policy parameters.
Field | Default | |
offered-measurement | ||
high-rate-hold-time | 0 | |
time-average-factor | 0 | |
sample-interval | 4 | |
Delete advanced policies from the following entities:
Use the following CLI syntax to delete advanced policies from ingress queue groups.
Use the following CLI syntax to delete advanced policies from egress queue groups.
Use the following CLI syntax to delete advanced policies from an ingress SAP.
Use the following CLI syntax to delete advanced policies from an egress SAP.
You can copy an existing advanced policy, rename it with a new policy ID value, or overwrite an existing policy ID. The overwrite option must be specified or an error occurs if the destination policy ID exists.
You can change existing advanced policies and entries in the CLI or NMS. The changes are applied immediately to all services where this policy is applied. To prevent configuration errors copy the policy to a work area, make the edits, and then write over the original policy.