ATM interface configurations

Use the following CLI syntax to configure ATM interface parameters for SONET/SDH paths:

config# port port-id 
    — sonet-sdh
        — path [sonet-sdh-index]
                — atm
                    — cell-format cell-format
                    — ilmi [vpi/vci]
                        — egress
    traffic-desc traffic-desc-profile-id
                        — ingress
    traffic-desc traffic-desc-profile-id
                        — keep-alive [poll-frequency seconds] [poll-count value] [test-frequency seconds]
                        — protocol protocol-type
                        — [no] shutdown
                    — min-vp-vpi value

Use the following CLI syntax to configure ATM interface parameters for IMA bundles.

config>port>multilink-bundle
    — ima
        — atm
            — cell-format cell-format
            — min-vp-vpi value

Use the following CLI syntax to configure ATM interface parameters for TDM channels:

config# port {port-id}
    — tdm
        — ds1 [ds1-id]
            — channel-group 1
                — atm
                    — cell-format cell-format
                    — min-vp-vpi value
        — ds3 [sonet-sdh-index]
            — atm
                — cell-format cell-format
                — min-vp-vpi value
                — mapping {direct | plcp}
        — e1 [e1-id]
            — channel-group 1
                — atm
                    — cell-format cell-format
                    — min-vp-vpi value
        — e3 [sonet-sdh-index]
            — atm
                — cell-format cell-format
                — min-vp-vpi value