29. y Commands

29.1. yang-modules

yang-modules

Syntax 
yang-modules
Context 
[Tree] (config>system>management-interface yang-modules)
Full Contexts 
configure system management-interface yang-modules
Supported Platforms 

All

Description 

Commands in this context configure YANG module parameters.

The yang-modules settings affect the data sent in a NETCONF <hello>, data populated in the RFC 6022 /netconf-state/schemas list, data returned in a <get-schema> request, and data populated in the RFC 8525 /yang-library. See the 7450 ESS, 7750 SR, 7950 XRS, and VSR System Management Guide, sections “NETCONF Monitoring” and “YANG Library” for more information.

29.2. yellow-differential-delay

yellow-differential-delay

Syntax 
yellow-differential-delay yellow-diff-delay
no yellow-differential-delay
Context 
[Tree] (config>port>multilink-bundle yellow-differential-delay)
Full Contexts 
configure port multilink-bundle yellow-differential-delay
Supported Platforms 

7450 ESS, 7750 SR-7/12/12e

Description 

This command sets the yellow warning threshold for the differential delay for members within a multilink bundle. If circuit’s delay exceeds the yellow-differential delay value, a log message and SNMP trap is sent. This command is only valid for MLPPP bundles. The differential delay is calculated as the round-trip differential delay for MLPPP bundles.

The no form of this command removes the yellow-differential-delay.

Parameters 
yellow-diff-delay —
Specifies the maximum yellow differential delay threshold value, in milliseconds.
Values—
1 to 25