Access Multi-Homing over MPLS for PBB Epipes

This section gives an example configuration for BEB1 from Figure 1.

*A:BEB1>config>service# info
----------------------------------------------
        pbb
            source-bmac 00:00:00:00:11:11
            mac-name "remote-BEB" 00:44:44:44:44:44
        exit
        sdp 1 mpls create
            far-end 10.1.1.4
            ldp
            keep-alive
                shutdown
            exit
            source-bmac-lsb 33:33 control-pw-vc-id 100
            no shutdown
        exit
        vpls 10 customer 1 b-vpls create
            service-mtu 1532
            stp
                shutdown
            exit
            spb 1024 fid 1 create
                no shutdown
            exit
            sap 1/1/1:10 create
                spb create
                    no shutdown
                exit
            exit
            sap 1/1/5:10 create
                spb create
                    no shutdown
                exit
            exit
            no shutdown
        exit
        epipe 100 customer 1 create
            pbb
                tunnel 10 backbone-dest-mac "remote-BEB" isid 100
            exit
            spoke-sdp 1:100 create
                use-sdp-bmac
                no shutdown
            exit
            no shutdown
        exit
        epipe 101 customer 1 create
            pbb
                tunnel 10 backbone-dest-mac "remote-BEB" isid 101
            exit
            spoke-sdp 1:101 create
                use-sdp-bmac
                no shutdown
            exit
            no shutdown
        exit
----------------------------------------------
*A:BEB1>config>service#

The SDP control pseudowire information can be seen using this command:

*A:BEB1# show service sdp 1 detail

===============================================================================
Service Destination Point (Sdp Id : 1) Details
===============================================================================
-------------------------------------------------------------------------------
 Sdp Id 1  -10.1.1.4
-------------------------------------------------------------------------------
Description           : (Not Specified)
SDP Id               : 1                     SDP Source         : manual
...
Src B-MAC LSB        : 33-33                 Ctrl PW VC ID      : 100
Ctrl PW Active       : Yes

...
===============================================================================
*A:BEB1#

The configuration of a pseudowire to support remote active/standby PBB Epipe operation can be seen using this command:

*A:BEB1# show service id 100 sdp 1:100 detail

===============================================================================
Service Destination Point (Sdp Id : 1:100) Details
===============================================================================
-------------------------------------------------------------------------------
 Sdp Id 1:100  -(10.1.1.4)
-------------------------------------------------------------------------------
Description     : (Not Specified)
SDP Id             : 1:100                    Type              : Spoke
...
Use SDP B-MAC      : True
...
===============================================================================
*A:BEB1#8.C