Further recommendations and more information about LI are as follows:
In mixed configuration mode, all users (LI and non-LI users) should only use private candidate for configuration, to allow classic interfaces such as SNMP to manage the router.
Other model-driven interfaces such as NETCONF can perform an exclusive lock on the LI configuration. This prevents direct CLI configuration and therefore, the best way to configure LI is to use a single model-driven interface at a time.
Command completion of parameter values between the LI and configure regions is not supported in the MD-CLI.
When the li-separate command is enabled, the MD-CLI does not support the load or rollback commands in the LI and configure regions.
The LI configuration is not saved to the startup configuration file when changes are committed. Configuration changes must be manually saved with the MD-CLI admin save configuration li command.
If the LI configuration file fails to load at boot, the admin show configuration li command can be used to view the LI configuration file by the LI administrator.