Existing mirroring parameters can be modified in the CLI. The changes are applied immediately. The service must be shut down if changes to the SAP are made.
In the following example, the mirror destination is changed from 10.10.10.2 (ALA-B) to 10.10.10.3 (SR3). Note that the mirror-dest service ID on ALA-B must be shut down first before it can be deleted.
The following example shows the commands to modify parameters for a remote mirrored service:
*A:ALA-A>config>mirror# mirror-dest 104
config>mirror>mirror-dest# remote-source
config>mirror>mirror-dest>remote-source# no far-end
10.10.10.2
remote-source# far-end 10.10.10.3 ing-svc-label 3500
*A:ALA-B>config>mirror# mirror-dest 104
config>mirror>mirror-dest# shutdown
config>mirror>mirror-dest# exit
config>mirror# no mirror-dest 104
SR3>config>mirror# mirror-dest 104 create
config>mirror>mirror-dest# spoke-sdp 4:60 egress vc-
label 3500
config>mirror>mirror-dest# no shutdown
config>mirror>mirror-dest# exit all
SR3># debug
debug# mirror-source 104
debug>mirror-source# port 551/1/2 ingress egress
debug>mirror-source# no shutdown*A:ALA-A>config>mirror# info
----------------------------------------------
mirror-dest 104 create
remote-source
far-end 10.10.10.3 ing-svc-label 3500
exit
sap 2/1/15:0 create
egress
qos 1
exit
exit
no shutdown
exit
A:SR3>config>mirror# info
----------------------------------------------
mirror-dest 104 create
spoke-sdp 4:60 egress vc-label 3500
no shutdown
exit
----------------------------------------------
A:SR3>config>mirror#
A:SR3# show debug mirror
debug
mirror-source 104
no shutdown
port 5/1/2 egress ingress
exit
exit
A:SR3#