OSPF application specific TE link attributes

Existing OSPFv2 TE-related link attribute advertisement (for example, bandwidth) definitions are used in RSVP-TE deployments (see draft-ietf-spring-segment-routing-policy-07.txt for more information). Because the definition of the original RSVP-TE use case, additional applications (for example, Segment Routing Traffic Engineering (SR-TE)) that may use the link attribute advertisement have also been defined.

This usage has introduced ambiguity in deployments that include a mix of RSVP-TE and SR-TE support. For example, it is not possible to unambiguously indicate the specific advertisements used by RSVP-TE and SR-TE. Although this may not be an issue for fully congruent topologies, any incongruence causes ambiguity. An additional issue arises in cases where both applications are supported on a link but the link attribute values associated with each application differ. Advertisements without OSPFv2 application specific TE link attributes do not support the advertisement of application specific values for the same attribute on a specific link.

CLI syntax:

Config
   router
      ospf
         traffic-engineering-options
               sr-te {legacy|application-specific-link-attributes}
               no sr-te 

The traffic-engineering-options command enables the context to configure advertisement of the TE attributes of each link on a per-application basis. Two applications are supported in SR OS: RSVP-TE and SR-TE.

The legacy mode of advertising TE attributes that is used in RSVP-TE is still supported. In addition, the following configuration options are allowed:

no sr-te

advertises the TE information for RSVP links using TE Opaque LSAs. The no form is the default value.

sr-te legacy

advertises the TE information for MPLS-enabled SR links using TE Opaque LSAs

Note: The operator should not use the sr-te legacy option if the network has both RSVP-TE and SR-TE, and the links are not congruent.

sr-te application-specific-link-attributes

advertises the TE information for MPLS-enabled SR links using the new Application Specific Link Attributes (ASLA) TLVs

The IETF Draft draft-ietf-ospf-te-link-attr-reuse-14.txt defines a subset of all possible TE extensions and TE Metric Extensions that can be encoded within Application Specific Link sub TLVs. Table: Nokia support for ASLA extended link TLV encoding describes the relevant values for SR OS.

The solution proposed in the OSPF Link Traffic Engineering Attribute Reuse Draft (draft-ietf-ospf-te-link-attr-reuse-14.txt) assumes that OSPF does not need to move all RSVP-TE attributes from the TE Opaque LSA into the Extended Link LSA. For, RSVP-TE, consequently, there is no significant modification and it can continue to be advertised using existing OSPF TLVs. For SR-TE and future applications, the ASLA TLVs may be used. Alternatively, existing TE Opaque LSAs could be used through configuration. Table: Configuration considerations for TE opaque LSAs describes the possible configurations for TE Opaque LSAs.