[no] damping name
config>router>policy-options
Supported on all 7210 SAS platforms as described in this document
This command creates the context to configure a route damping profile to use in route policy entries.
The no form of this command deletes the named route damping profile.
Specifies the damping profile name. Allowed values are any string up to 32 characters composed of printable, 7-bit ASCII characters. If the string contains special characters (#, $, spaces, and so on), the entire string must be enclosed within double quotes.
half-life minutes
no half-life
config>router>policy-options>damping
Supported on all 7210 SAS platforms as described in this document
This command configures the half-life parameter for the route damping profile.
The half life value is the time, expressed in minutes, required for a route to remain stable for the Figure of Merit (FoM) value to be reduced by one half; for example, if the half life value is 6 (minutes) and the route remains stable for 6 minutes, the new FoM value is 3 (minutes). After another 3 minutes pass and the route remains stable, the new FoM value is 1.5 (minutes).
When the FoM value falls below the reuse threshold, the route is again considered valid and can be reused or included in route advertisements. No half life value is specified. The half life value must be explicitly configured.
The no form of this command removes the half life parameter from the damping profile.
Specifies the half life, in minutes, expressed as a decimal integer.
max-suppress minutes
no max-suppress
config>router>policy-options>damping
Supported on all 7210 SAS platforms as described in this document
This command configures the maximum suppression parameter for the route damping profile.
This value indicates the maximum time, expressed in minutes, that a route can remain suppressed.
The no form of this command removes the maximum suppression parameter from the damping profile.
Specifies the maximum suppression time, in minutes, expressed as a decimal integer.
reuse integer
no reuse
config>router>policy-options>damping
Supported on all 7210 SAS platforms as described in this document
This command configures the reuse parameter for the route damping profile.
When the FoM value falls below the reuse threshold, the route is again considered valid and can be reused or included in route advertisements.
The no form of this command removes the reuse parameter from the damping profile.
Specifies the reuse value, expressed as a decimal integer.
suppress integer
no suppress
config>router>policy-options>damping
Supported on all 7210 SAS platforms as described in this document
This command configures the suppression parameter for the route policy damping profile.
A route is suppressed when it has flapped frequently enough to increase the FoM value to exceed the suppress threshold limit. When the FoM value exceeds the suppress threshold limit, the route is removed from the route table or inclusion in advertisements.
The no form of this command removes the suppress parameter from the damping profile.
Specifies the suppress value, expressed as a decimal integer.