The following is a sample port loopback MAC swap configuration output using the service and SAP.
configure> system> loopback-no-svc-port testhead <port-id>
*A:7210SAS>config>system# info
----------------------------------------------
.............
resource-profile
ingress-internal-tcam
qos-sap-ingress-resource 5
exit
acl-sap-ingress 5
exit
exit
egress-internal-tcam
exit
exit
loopback-no-svc-port mac-swap 1/1/8 testhead 1/1/11
..............
The following is a sample port loopback with MAC swap configuration output on the remote end.
*A:7210SAS# configure system loopback-no-svc-port mac-swap 1/1/8
*A:7210SAS# configure system
*A:7210SAS>config>system# info
----------------------------------------------
alarm-contact-input 1
shutdown
exit
alarm-contact-input 2
shutdown
exit
alarm-contact-input 3
shutdown
exit
alarm-contact-input 4
shutdown
exit
resource-profile
ingress-internal-tcam
qos-sap-ingress-resource 5
exit
acl-sap-ingress 5
exit
exit
egress-internal-tcam
exit
exit
loopback-no-svc-port mac-swap 1/1/8 testhead 1/1/11
.................
The following is a sample testhead profile configuration output.
*A:7210SAS# configure test-oam testhead-profile 1
*A:7210SAS>config>test-oam>testhd-prof# info
----------------------------------------------
description "Testhead_Profile_1"
frame-size 512
rate cir 100 adaptation-rule max pir 200
dot1p in-profile 2 out-profile 4
frame-payload 1 payload-type tcp-ipv4 create
description "Frame_Payload_1"
dscp "af11"
dst-ip ipv4 10.2.2.2
dst-mac 00:00:00:00:00:02
src-mac 00:00:00:00:00:01
dst-port 50
src-port 40
ip-proto 6
ip-tos 8
ip-ttl 64
src-ip ipv4 10.1.1.1
exit
acceptance-criteria 1 create
jitter-rising-threshold 100
jitter-rising-threshold-in 100
jitter-rising-threshold-out 100
latency-rising-threshold 100
latency-rising-threshold-in 100
latency-rising-threshold-out 100
loss-rising-threshold 100
loss-rising-threshold-in 100
loss-rising-threshold-out 100
cir-threshold 1000
pir-threshold 2000
exit
----------------------------------------------
*A:7210SAS>config>test-oam>testhd-prof#
The following command is used to execute the testhead profile.
*A:7210SAS# oam testhead testhead-profile 1 frame-payload 1 sap 1/1/2 test-
me owner ownerme color-aware enable