See the 7705 SAR Interface Configuration Guide, ‟7705 SAR Interfaces”, for LLDP Ethernet port commands.
lldp
config>system
This command enables the context to configure system-wide Link Layer Discovery Protocol (LLDP) parameters.
message-fast-tx time
no message-fast-tx
config>system>lldp
This command configures the interval between LLDPDU transmissions by the LLDP agent during a fast transmission period.
The fast transmission period begins when a new neighbor is detected. During the fast transmission period, LLDPDUs are transmitted at shorter intervals than the standard tx-interval to ensure that more than one LLDPDU is sent to the new neighbor. The first transmission occurs as soon as the new neighbor is detected. The length of the fast transmission period is determined by the number of LLDPDU transmissions (configured by the message-fast-tx-init command) and the interval between them.
The no form of the command reverts to the default value.
1
specifies the interval between LLDPDU transmissions in seconds
message-fast-tx-init count
no message-fast-tx-init
config>system>lldp
This command configures the number of LLDPDUs to send during a fast transmission period.
The fast transmission period begins when a new neighbor is detected. During the fast transmission period, LLDPDUs are transmitted at shorter intervals than the standard tx-interval to ensure that more than one LLDPDU is sent to the new neighbor. The first transmission occurs as soon as the new neighbor is detected. The length of the fast transmission period is determined by the number of LLDPDU transmissions and the interval between them (configured by the message-fast-tx command).
The no form of the command reverts to the default value.
4
specifies the number of LLDPDUs to send during the fast transmission period
notification-interval time
no notification-interval
config>system>lldp
This command configures the minimum time between change notifications. A change notification is a trap message sent to SNMP whenever a change occurs in the database of LLDP information.
The no form of the command reverts to the default value.
5
specifies the minimum time, in seconds, between change notifications
reinit-delay time
no reinit-delay
config>system>lldp
This command configures the time before reinitializing LLDP on a port.
The no form of the command reverts to the default value.
2
specifies the time, in seconds, before reinitializing LLDP on a port
tx-credit-max count
no tx-credit-max
config>system>lldp
This command configures the maximum number of consecutive LLDPDUs that can be transmitted at any time.
The no form of the command reverts to the default value.
5
specifies the maximum number of consecutive LLDPDUs transmitted
tx-hold-multiplier multiplier
no tx-hold-multiplier
config>system>lldp
This command configures the multiplier of the transmit interval defined by the tx-interval command.
The transmit interval time multiplied by the tx-hold-multiplier is the TTL value in the LLDPDU. The TTL value determines the amount of time the receiving device retains LLDP packet information in local information databases before discarding it.
The no form of the command reverts to the default value.
4
specifies the multiplier of the transmit interval
tx-interval interval
no tx-interval
config>system>lldp
This command configures the LLDP transmit interval time.
The no form of the command reverts to the default value.
30
specifies the LLDP transmit interval time in seconds