saa-test [test-name [owner test-owner]]
clear
This command clears the SAA results for the specified test and the history for the test. If the test name is omitted, all the results for all tests are cleared.
specifies the SAA test to clear. The test name must already be configured in the config>saa>test context.
specifies the owner of an SAA operation, up to 32 characters in length
dual-ended-loss-test mep mep-id domain md-index association ma-index
clear>eth-cfm
This command clears the accumulated frame counters during a dual-ended loss measurement (LM) test.
The LM counters are reset when a MEP on the datapath is created or deleted automatically by the system for network or configuration reasons. Some of the reasons for creating or deleting a MEP are as follows, excluding the general functions of manually creating or deleting a MEP:
for SAPs
changing the ccm-ltm-priority using the CLI or SNMP
changing the ccm-interval using the CLI or SNMP
changing the SAP egress QoS policy
changes to the SAP state (due to, for example, moving (bouncing) ports, link loss forwarding (LLF), or network changes that require recreation of flows)
for spoke SDPs
changing the VC type on the spoke SDP
changing the VC vc-tag on the spoke SDP
changing the VC etype on the spoke SDP
change to the spoke SDP state due to network conditions
The clear>dual-ended loss-test command only resets the ‟Accumulated Frames During the Test” results for both the far end and near end. The frame counters for aggregated results are not reset. See Output Example - before fewer than two CCMs.
specifies the target MEP ID
displays the index of the MD to which the MEP is associated, or 0, if none
displays the index of the MA to which the MEP is associated, or 0, if none
The following outputs are examples of displays after a show>eth-cfm>.....>dual-ended-loss-test command is issued:
before receiving fewer than two CCMs after the clear command is issued
after receiving two or more CCMs after the clear command is issued
===============================================================================
Eth CFM Dual-Ended Test Result
===============================================================================
Far-End Mac Addr : 00:1a:f0:69:d4:a6 Duration (sec) : 0
Latest Frame Counters In Previous CCM In Current CCM Delta
TxLocal : 0 0 0
RxFarEnd : 0 0 0
TxFarEnd : 0 0 0
RxLocal : 0 0 0
Accumulated Frames During Test Near-End Far-End
Total Tx : 0 0
Total Rx : 0 0
Total Loss : 0 0
Loss Ratio(%) : 0.00 0.00
===============================================================================
===============================================================================
Eth CFM Dual-Ended Test Result
===============================================================================
Far-End Mac Addr : 00:1a:f0:69:d4:a6 Duration (sec) : 2
Latest Frame Counters In Previous CCM In Current CCM Delta
TxLocal : 123556 123566 10
RxFarEnd : 123550 123560 10
TxFarEnd : 123550 123560 10
RxLocal : 123556 123566 10
Accumulated Frames During Test Near-End Far-End
Total Tx : 10 10
Total Rx : 10 10
Total Loss : 0 0
Loss Ratio(%) : 0.00 0.00
=======================================================================
server
clear>test-oam>twamp>
This command clears the statistics for the TWAMP server.
testhead [result] [test-name [owner test-owner]]
clear
This command clears the ITU-T Y.1564 test head statistics.
specifies a Y.1564 test to clear
clears all Y.1564 tests assigned to a specific owner