dot1p {dot1p-value | in-profile dot1p-value out-profile dot1p-value}
no dot1p
config>qos>sap-egress>fc
This command explicitly defines the egress dot1p priority bits values for the forwarding class.
When the dot1p dot1p-value command is used, the value is applied to both in-profile and out-of-profile packets. When the dot1p in-profile dot1p-value out-profile dot1p-value form is used, different dot1p values for in-profile or out-of-profile packets can be specified.
For QinQ applications, the top and bottom dot1p bits or top-only dot1p bits are set based on the qinq-mark-top-only configuration. For more information, refer to the command description and the ‟QinQ Top-Only Mark Option” section in the 7705 SAR Services Guide.
The no form of the command sets the dot1p priority bits value to 0.
0
the explicit dot1p value for the specified forwarding class. Setting the value to 0 is equivalent to removing the marking value.
the dot1p in-profile mapping for the specified forwarding class. Setting the value to 0 is equivalent to removing the mapping value.
the dot1p out-profile mapping for the specified forwarding class. Setting the value to 0 is equivalent to removing the mapping value.
dscp dscp-name
dscp in-profile dscp-name out-profile dscp-name
no dscp
config>qos>sap-egress>fc
This command defines the DSCP name or DSCP priority bits mapping for the forwarding class.
When the dscp dscp-name command is used, the dscp-name is applied to all packets regardless of the profile state. The in-profile and out-profile form of the command allows differentiated values to be applied to packets based on the profile state.
Access IP traffic (that is, VPRN and IES access interfaces) will always be re-marked if the interfaces are configured as part of the SAP egress QoS policy.
The no form of the command removes the DSCP mapping associated with the forwarding class.
n/a
a system-defined, case-sensitive name
the DSCP in-profile mapping for the specified forwarding class
the DSCP out-profile mapping for the specified forwarding class
queue queue-id
no queue
config>qos>sap-egress>fc
This command specifies the egress queue to which the traffic associated with the forwarding class is to be forwarded. The command overrides the default queue mapping for fc fc-name. The specified queue-id must exist within the policy before the mapping can be made. Once the forwarding class mapping is executed, all traffic classified to the fc-name on a SAP using this policy will use the indicated queue.
The no form of the command sets the queue-id back to the default queue for the forwarding class (queue 1).
no queue
the service egress queue-id to be associated with the forwarding class. The queue-id must be an existing queue defined in sap-egress policy-id.