Serial raw socket interface configuration commands

Note:

To enable the serial transport over raw socket functionality on 7705 SAR-Hm series nodes, configure an RS-232 raw socket serial port and create an IP transport subservice within a VPRN service. For information about how to configure an IP transport subservice within a VPRN, see the 7705 SAR-Hm and SAR-Hmc Main Configuration Guide, Layer 2 and Layer 3 Services chapter, "Serial raw socket IP transport configuration commands hierarchy".

config 
    - [no] port port-id
        - serial
            - [no] rs232
                - socket 
                    - rx 
                        - eop
                            - idle-timeout milliseconds
                            - length bytes
                            - special-char value
                            - no special-char
                        - squelch-delay seconds
                        - no squelch-delay 
                        - squelch-reset
                        - unsquelch-delay seconds
                        - no unsquelch-delay
                    - tx
                        - inter-session-delay milliseconds