Table: Router instance match criteria describes the supported MAC match criteria. The criteria are evaluated against the Ethernet header of the Ethernet frame.
| Criteria | Description |
|---|---|
frame-type |
Matches a specific type of frame format. |
src-mac |
Matches the specified source MAC address frames. Optionally, operators can configure a mask to be used in a match. |
dst-mac |
Matches the specified destination MAC address frames. Optionally, operators can configure a mask to be used in a match. |
dot1p |
Matches 802.1p frames. Optionally, operators can configure a mask to be used in a match. |
etype |
Matches the specified Ethernet II frames. The Ethernet type field is a two-byte field used to identify the protocol carried by the Ethernet frame. |
snap-oui |
Matches frames with the specified three-byte OUI field. |
snap-pid |
Matches frames with the specified two-byte protocol ID that follows the three-byte OUI field. |
ssap |
Matches the specified frames with a source access point on the network node designated in the source field of the packet. Optionally, operators can configure a mask to be used in a match. |
dsap |
Matches the specified frames with a destination access point on the network node designated in the destination field of the packet. Optionally, operators can configure a mask to be used in a match. |
cfm-opcode |
Matches the specified packet with the specified cfm-opcode. |
svc-id |
Matches the service ID packets are ingressing from. |
svc-name |
Matches the service name packets are ingressing from. |